Douglas Hadron 625 FX NA - Thoughts or Opinions?

Post Reply
User avatar
Lamf77
Reactions:
Posts: 323
Joined: Wed May 27, 2020 11:56 pm

A Douglas Hadron 625 FX NA has gone for sale local. Looks to be in good shape, but it's a bit of a ride to be disappointed.
Just wondering if anyone here has any opinions? Gosh I miss the old board!
Thanks!

https://www.rondomusic.com/hadron625nafx.html
Tonray's Ghost
Reactions:
Posts: 1807
Joined: Thu May 28, 2020 7:14 am

https://www.home.cern/science/accelerat ... n-collider

Just be careful...anything above the 21st fret can open a black hole into the noodle universe
User avatar
Lamf77
Reactions:
Posts: 323
Joined: Wed May 27, 2020 11:56 pm

Tonray's Ghost wrote: Thu Mar 09, 2023 6:47 pm https://www.home.cern/science/accelerat ... n-collider

Just be careful...anything above the 21st fret can open a black hole into the noodle universe
Exactly the information I was looking for........not. ;)
User avatar
dabbler
Reactions:
Posts: 457
Joined: Sat May 30, 2020 6:39 pm
Location: Maryland

I don't have any experience with that PARTICULAR model, but I have a couple of its cousins:
P1000043.JPG
P1000044.JPG
PXL_20230310_015819049.jpg
and they are both solid players!
User avatar
toomanycats
Reactions:
Posts: 1837
Joined: Wed May 27, 2020 7:43 pm

What I have to offer really is just an opinion, because I have nothing to offer on the basis of experience regarding that particular make and model.

That being said . . .

If your looking for a shreddy metal type guitar . . .
. . . and if you prefer a fixed bridge (string through at that) . . .
. . . and if it's being offered at a price roughly equivalent to or less than the original $179.95 Rondo price . . .

. . . Then you're most likely not going to find a better deal on a neck through body guitar. I'm sure I'm not telling you anything you don't already know in saying that neck through guitars are synonymous with Jackson and BC Rich. If that instrument had either of those names on the headstock it could be sold for several times over the original Rondo sale price.

If you want to turn it into a serious professional instrument I'd expect to upgrade some of the electronics and hardware . . . but then again, maybe not. You never know until you play the thing. Sometimes a "cheap" guitar will surprise you.

With it's Jackson shark fretboard inlays, BC Rich-esque Gunslinger headstock, and classic Ibanez RG HSH pickup layout, I personally think that guitar is a a super cool super-strat mash-up.

What is the asking price anyways? That's a significant factor.

hadron625fxna1.jpg
“There are only two means of refuge from the miseries of life: Music and Cats!” Albert Schweitzer
User avatar
Rollin Hand
Reactions:
Posts: 1413
Joined: Wed May 27, 2020 1:38 pm

Frig, now I want one of these again.

Like, bad.
"I'm not a sore loser. It's just that I prefer to win, and when I don't, I get furious."
- Ron Swanson
User avatar
Lamf77
Reactions:
Posts: 323
Joined: Wed May 27, 2020 11:56 pm

toomanycats wrote: Fri Mar 10, 2023 7:18 am What I have to offer really is just an opinion, because I have nothing to offer on the basis of experience regarding that particular make and model.

That being said . . .

If your looking for a shreddy metal type guitar . . .
. . . and if you prefer a fixed bridge (string through at that) . . .
. . . and if it's being offered at a price roughly equivalent to or less than the original $179.95 Rondo price . . .

. . . Then you're most likely not going to find a better deal on a neck through body guitar. I'm sure I'm not telling you anything you don't already know in saying that neck through guitars are synonymous with Jackson and BC Rich. If that instrument had either of those names on the headstock it could be sold for several times over the original Rondo sale price.

If you want to turn it into a serious professional instrument I'd expect to upgrade some of the electronics and hardware . . . but then again, maybe not. You never know until you play the thing. Sometimes a "cheap" guitar will surprise you.

With it's Jackson shark fretboard inlays, BC Rich-esque Gunslinger headstock, and classic Ibanez RG HSH pickup layout, I personally think that guitar is a a super cool super-strat mash-up.

What is the asking price anyways? That's a significant factor.


hadron625fxna1.jpg
Based on this....I went to check it out. Was only a 20 minute ride. The guitar seemed off. The action was off, a few minor dings (but in conspicuous areas), lots of buzz on the lower strings and both control knobs were loose (no big deal, but). Seller said "It was my sons and it has been sitting in the basement for a few years" and with no case. Even at $130 I took a pass. Enough projects in the que. Thanks for all the advice though!
User avatar
sabasgr68
Reactions:
Posts: 1362
Joined: Wed May 27, 2020 10:11 pm
Location: Venezuela, Caracas
Gearlist: Mossman Sunking Strat (model MN001) - Zoom G3xn - My hands
Contact:

Lamf77 wrote: Fri Mar 10, 2023 7:14 pm
toomanycats wrote: Fri Mar 10, 2023 7:18 am What I have to offer really is just an opinion, because I have nothing to offer on the basis of experience regarding that particular make and model.

That being said . . .

If your looking for a shreddy metal type guitar . . .
. . . and if you prefer a fixed bridge (string through at that) . . .
. . . and if it's being offered at a price roughly equivalent to or less than the original $179.95 Rondo price . . .

. . . Then you're most likely not going to find a better deal on a neck through body guitar. I'm sure I'm not telling you anything you don't already know in saying that neck through guitars are synonymous with Jackson and BC Rich. If that instrument had either of those names on the headstock it could be sold for several times over the original Rondo sale price.

If you want to turn it into a serious professional instrument I'd expect to upgrade some of the electronics and hardware . . . but then again, maybe not. You never know until you play the thing. Sometimes a "cheap" guitar will surprise you.

With it's Jackson shark fretboard inlays, BC Rich-esque Gunslinger headstock, and classic Ibanez RG HSH pickup layout, I personally think that guitar is a a super cool super-strat mash-up.

What is the asking price anyways? That's a significant factor.


hadron625fxna1.jpg
Based on this....I went to check it out. Was only a 20 minute ride. The guitar seemed off. The action was off, a few minor dings (but in conspicuous areas), lots of buzz on the lower strings and both control knobs were loose (no big deal, but). Seller said "It was my sons and it has been sitting in the basement for a few years" and with no case. Even at $130 I took a pass. Enough projects in the que. Thanks for all the advice though!
If it didn´t have that many "buts" it would have been a nice thing to grab. I like it; the back looks awesome! (but a guitar is more about playing than looking!)

Keep on searching, Mike! :)
I´m the guy from Venezuela (Not Communist/Socialist) - Catholic - Husband - Father
Looking for online/remote job - Income on the internet
Always grateful to the AGF community and friends
AGF refugee - Banned by MOMO
User avatar
JeffBeck
Reactions:
Posts: 392
Joined: Wed May 27, 2020 4:10 pm

Those damn things still sort of haunt me. I talked myself out of one on several occasions. Wish I had just ignored me.
User avatar
artandsoul
Reactions:
Posts: 185
Joined: Fri Jan 22, 2021 7:11 pm
Location: south

I would have offered 100! it was worth 100 but its a douglas not an agile or decent Ibanez, and needing work its 100 lol
"Nationwide, on average 21% of adults in the US are illiterate in 2023. 54% of adults have a literacy below 6th grade level" Now I know whats wrong with people lmao
bc rich
Reactions:
Posts: 153
Joined: Sun Jul 26, 2020 12:26 pm

DSCF3358.JPG
It is worth way more than $100 . A chance to buy a unique guitar at an under the radar of the sniffers price.
I have kept mine stock even the pickups , one regret is that it is trans blue and hard to see the wood glory unless outside or under bright lighting.

.
User avatar
Rollin Hand
Reactions:
Posts: 1413
Joined: Wed May 27, 2020 1:38 pm

JeffBeck wrote: Fri Mar 17, 2023 9:31 pm Those damn things still sort of haunt me. I talked myself out of one on several occasions. Wish I had just ignored me.
JB is back!

I talked myself out of 6 and 7 string Hadrons, and the SEG1 Ash, multiple times.

Have I mentioned that I am dumber than a bag of hair?

Sill have my Spad with the effing awful fretwork that's never had working electronics. And my Douglas Scope 725.

If I ever attempt a fret job, it will be on the Spad.
"I'm not a sore loser. It's just that I prefer to win, and when I don't, I get furious."
- Ron Swanson
User avatar
JeffBeck
Reactions:
Posts: 392
Joined: Wed May 27, 2020 4:10 pm

Rollin Hand wrote: Sat Mar 18, 2023 9:35 am
JeffBeck wrote: Fri Mar 17, 2023 9:31 pm Those damn things still sort of haunt me. I talked myself out of one on several occasions. Wish I had just ignored me.
JB is back!

I talked myself out of 6 and 7 string Hadrons, and the SEG1 Ash, multiple times.

Have I mentioned that I am dumber than a bag of hair?

Sill have my Spad with the effing awful fretwork that's never had working electronics. And my Douglas Scope 725.

If I ever attempt a fret job, it will be on the Spad.
I was silly enough to sell my Spad. I truly regret that. Dumb, awful, move. I just consider it a life-lesson now.
User avatar
Rollin Hand
Reactions:
Posts: 1413
Joined: Wed May 27, 2020 1:38 pm

JeffBeck wrote: Sat Mar 18, 2023 9:50 am
Rollin Hand wrote: Sat Mar 18, 2023 9:35 am
JeffBeck wrote: Fri Mar 17, 2023 9:31 pm Those damn things still sort of haunt me. I talked myself out of one on several occasions. Wish I had just ignored me.
JB is back!

I talked myself out of 6 and 7 string Hadrons, and the SEG1 Ash, multiple times.

Have I mentioned that I am dumber than a bag of hair?

Sill have my Spad with the effing awful fretwork that's never had working electronics. And my Douglas Scope 725.

If I ever attempt a fret job, it will be on the Spad.
I was silly enough to sell my Spad. I truly regret that. Dumb, awful, move. I just consider it a life-lesson now.

I love my Spad, even with the issues. I just wish that a) I could wire/solder worth a damn, and b) the high E would stop getting caught UNDER the edge of the 7th fret.

At this stage, I figure it isn't worth anything, so why not try stuff with it? I might even learn something.
"I'm not a sore loser. It's just that I prefer to win, and when I don't, I get furious."
- Ron Swanson
Post Reply