Add these to the recent pedal purchases:
J. Rockett "The Animal"
Vox Valvenergy Mystic Edge AC Style Analog Pedal w/ NuTub
Whats your' latest gear acquisition?
- Perfect Stranger
- Reactions:
- Posts: 151
- Joined: Thu May 28, 2020 5:43 am
- Location: Athens, GA - Dawg Country
- Contact:
~Jim~
Even great harmonica players suck half the time!
Even great harmonica players suck half the time!
That's funny, I found one of those at a local thrift store a while back. They almost never carry any music stuff, so I kind of had to grab it on principle (not sure what the principle was, other than "I will buy stupid crap I don't need if the price is right" ) If you're a big pedal-stepping kind of player, I could see it being very handy.
I love this thing wish I would have gotten one sooner. Being able to turn on/off multiple pedals at the same time is fun and very useful.glasshand wrote:That's funny, I found one of those at a local thrift store a while back. They almost never carry any music stuff, so I kind of had to grab it on principle (not sure what the principle was, other than "I will buy stupid crap I don't need if the price is right" ) If you're a big pedal-stepping kind of player, I could see it being very handy.
Sent from my iPhone using Tapatalk
- nomadh
- Reactions:
- Posts: 1745
- Joined: Wed May 27, 2020 1:32 pm
- Gearlist: My Gear:Electric
Gibson '13 studio dlx hsb
Gibson '79 flying V
Gibson '06 sg faded
Gibson '15 LP CM w gforce
Epiphone Casino coupe
Epiphone dot studio
Fender USA strat w mjt body _w Original body 81
Fender lead II
Firefly spalted 338
Squier affinity tele bsb
Squier strat std relic
Squier subsonic baritone
Agile al2500 albino
Agile al3001 hsb
Sx ash Ltd strat
Sx ash strat short scale
Sx ash tele
Sx callisto jr
Dean vendetta
Washburn firebird. Ps10
Johnson trans red strat
Johnson jazz box Vegas
Seville explorer
Inlaid tele
flametop bigsby tele wood inlaid neck
23
Acoustics
new Eastman acoustic
Sigma dm3 dread x2 (his and hers)
Fender 12 str
Ibanez exotic wood
Silvercreek rosewood 00
Ovation steel str
martin backpacker acoustic
Johnson dobro
After playing a few open pore acoustics maybe don't clog those "tone pores"Partscaster wrote: ↑Sun May 31, 2020 7:40 pm The alder body from a few posts up, turns out to be very nice, with good tap tones and very tight tolerances for the new neck into its neck pocket. The outfit is called Woodtech from Ohio, and on reverb.
I'm going to just put 2 or 3 birchwood-cassey tru-oil coats on it and leave it fairly raw. Same for the maple neck w/ rosewood. Just enough to close up the pores and leave a thin layer.
- nomadh
- Reactions:
- Posts: 1745
- Joined: Wed May 27, 2020 1:32 pm
- Gearlist: My Gear:Electric
Gibson '13 studio dlx hsb
Gibson '79 flying V
Gibson '06 sg faded
Gibson '15 LP CM w gforce
Epiphone Casino coupe
Epiphone dot studio
Fender USA strat w mjt body _w Original body 81
Fender lead II
Firefly spalted 338
Squier affinity tele bsb
Squier strat std relic
Squier subsonic baritone
Agile al2500 albino
Agile al3001 hsb
Sx ash Ltd strat
Sx ash strat short scale
Sx ash tele
Sx callisto jr
Dean vendetta
Washburn firebird. Ps10
Johnson trans red strat
Johnson jazz box Vegas
Seville explorer
Inlaid tele
flametop bigsby tele wood inlaid neck
23
Acoustics
new Eastman acoustic
Sigma dm3 dread x2 (his and hers)
Fender 12 str
Ibanez exotic wood
Silvercreek rosewood 00
Ovation steel str
martin backpacker acoustic
Johnson dobro
Just got a new firefly 338 spalted. I threatened early on that if they came up with a pretty one for not too much upcharge I'd bite.
So far I'm very impressed. For $200 shipped I'm crazy impressed. Got me thinking I can sell off my dot studio and my johnson jazz box I just don't use much.
review here. https://www.aguitarforum.net/viewtopic.php?f=11&t=1185
So far I'm very impressed. For $200 shipped I'm crazy impressed. Got me thinking I can sell off my dot studio and my johnson jazz box I just don't use much.
review here. https://www.aguitarforum.net/viewtopic.php?f=11&t=1185
- Gear_Junky
- Reactions:
- Posts: 624
- Joined: Thu Aug 20, 2020 12:08 pm
I've been playing the GC roulette and had various things cancelled a few times - because their inventory isn't updated in real time. This time they haven't cancelled the order since yesterday, so there's a chance that I'm getting this. Purportedly a 2012 Squier Classic Vibe 60's Jazzmaster. In my favorite color scheme for a JM. We'll see...
- Perfect Stranger
- Reactions:
- Posts: 151
- Joined: Thu May 28, 2020 5:43 am
- Location: Athens, GA - Dawg Country
- Contact:
Cool blanket....AND guitar
~Jim~
Even great harmonica players suck half the time!
Even great harmonica players suck half the time!
I just bought this on sale at Adorama.
They've had this deal before. Since I'm in a state that doesn't collect sales tax I'll get it a few hundred lower than most people. If I don't like it, I'd be surprised if I couldn't sell it locally in cash for what I paid for it (if outside of the return window).
I also bought a 96 Custom 22 10 top 1 week+ ago that I haven't taken pictures of. I got a pretty good deal but like all guitars I buy from Mike (local guy dude in cover band) it's a bit beat up.
They've had this deal before. Since I'm in a state that doesn't collect sales tax I'll get it a few hundred lower than most people. If I don't like it, I'd be surprised if I couldn't sell it locally in cash for what I paid for it (if outside of the return window).
I also bought a 96 Custom 22 10 top 1 week+ ago that I haven't taken pictures of. I got a pretty good deal but like all guitars I buy from Mike (local guy dude in cover band) it's a bit beat up.
- Rollin Hand
- Reactions:
- Posts: 1444
- Joined: Wed May 27, 2020 1:38 pm
Geez, that's nice. What make is it?
"I'm not a sore loser. It's just that I prefer to win, and when I don't, I get furious."
- Ron Swanson
- Ron Swanson
- slowhand84
- Reactions:
- Posts: 982
- Joined: Thu May 28, 2020 2:12 pm
It’s an early 80s D’Agostino, made in Japan. Scored it for $150. Thread is here
https://www.aguitarforum.net/viewtopic.php?f=6&t=1189
The last in my recent influx of boss pedals. this is a WEIRD one. PS-2 Pitch Shifter/Delay
this pedal has 6 modes:
1. 125ms delay
2. 500ms delay
3. 2s delay
4. manual pitch shift
5. +1 octave
6. -1 octave
the first knob (balance) is basically a mix knob that goes from dry signal only to effect only
second knob is feedback for the delay
third knob (fine/manual) controls the delay rate and the octave in mode 4
with the delays you can go from quick slapback to the full 2 sec repeats with everything in between via the fine knob. with the feedback at 9'oclock you get into self-oscillation for seemingly infinite repeats. you can actually get into looper style territory.
the octave up and downs are not the best sounding by modern standards - very sort of robotic and artificial. but certainly useable. the manual mode is a bit of an enigma outside of pure noisemaking.
this pedal has a unique character. everything sounds a little off somehow. the delay especially has a distinctive ambience about it.
with the ps-3 boss went for a much cleaner organic sounding pitch shifter, and i can understand why. the ps-2 doesn't seem to make a lot of sense to me on paper. and yet it's fascinatingly oddball and a lot fun. it will be interesting to see if i can actually find a lot of use for it. for now, it's the wild card on my board.
this is the video that really sold me on this one and it illustrates its capabilities well.
this pedal has 6 modes:
1. 125ms delay
2. 500ms delay
3. 2s delay
4. manual pitch shift
5. +1 octave
6. -1 octave
the first knob (balance) is basically a mix knob that goes from dry signal only to effect only
second knob is feedback for the delay
third knob (fine/manual) controls the delay rate and the octave in mode 4
with the delays you can go from quick slapback to the full 2 sec repeats with everything in between via the fine knob. with the feedback at 9'oclock you get into self-oscillation for seemingly infinite repeats. you can actually get into looper style territory.
the octave up and downs are not the best sounding by modern standards - very sort of robotic and artificial. but certainly useable. the manual mode is a bit of an enigma outside of pure noisemaking.
this pedal has a unique character. everything sounds a little off somehow. the delay especially has a distinctive ambience about it.
with the ps-3 boss went for a much cleaner organic sounding pitch shifter, and i can understand why. the ps-2 doesn't seem to make a lot of sense to me on paper. and yet it's fascinatingly oddball and a lot fun. it will be interesting to see if i can actually find a lot of use for it. for now, it's the wild card on my board.
this is the video that really sold me on this one and it illustrates its capabilities well.
frogs love to eat flies,
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
- Perfect Stranger
- Reactions:
- Posts: 151
- Joined: Thu May 28, 2020 5:43 am
- Location: Athens, GA - Dawg Country
- Contact:
Here's a new Mini pedal I just got.....
Wampler Belle Mini Pedal
https://www.wamplerpedals.com/products/ ... ive/belle/
And here's another new one that I LOVE!
Vox Valvenergy Mystic Edge AC Style Analog Pedal w/ NuTub
https://voxamps.com/product/mystic-edge/
Wampler Belle Mini Pedal
https://www.wamplerpedals.com/products/ ... ive/belle/
And here's another new one that I LOVE!
Vox Valvenergy Mystic Edge AC Style Analog Pedal w/ NuTub
https://voxamps.com/product/mystic-edge/
~Jim~
Even great harmonica players suck half the time!
Even great harmonica players suck half the time!
- mkgearhead
- Reactions:
- Posts: 103
- Joined: Thu May 28, 2020 8:46 pm
It got here about a week ago. Great guitar for $179 shipped.mkgearhead wrote: ↑Sat Oct 10, 2020 6:27 pm This will be here on Tuesday. They were supposed to be in stock in August but they finally came in stock on the 6th. Since it became available on the day EVH passed, I figured it was a sign that I should get it.
baretta.jpg
i will do a full thread on this thing later in the week after my first band practice with it...
...but after a over a decade, i once again own a tube amp
...but after a over a decade, i once again own a tube amp
frogs love to eat flies,
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
The FedEx delivery drivers (both of them) were not amused
frogs love to eat flies,
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
Remember to start with the volume and tone controls all on 10, and then turn down only if absolutely necessary!
I've only gotten it up to 5 so far - had no desire to go beyond that at the time
i don't think i'll ever hear this thing naturally distort
i think they start to break up around 7 or 8
frogs love to eat flies,
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
the devil's name, Beelzebub, lord of the flies
evil spirits love to spiritually feed upon those whom Beelzebub rules
joined AGF March 20, 2013
It depends on the pickup output, but you should start to get some natural breakup starting in the 6-7 range with vintage humbuckers or hot single coils. I actually often run mine dimed (volume, not tone!) but roll back the guitar volume. That said, I also typically run on just two power tubes to bring it down to 40 watts, and then I use a little attenuation to tame it further.
If you want to try lower power, you can pull either the inner pair or outer pair of power tubes. Just don’t hook up an external cab in parallel at the same time you do that as your impedance mismatch will get out of range. It’s still damn loud, but more manageable and a lot less work and heat for an attenuator if you use one.
If you want to try lower power, you can pull either the inner pair or outer pair of power tubes. Just don’t hook up an external cab in parallel at the same time you do that as your impedance mismatch will get out of range. It’s still damn loud, but more manageable and a lot less work and heat for an attenuator if you use one.
- mark_morton
- Reactions:
- Posts: 54
- Joined: Wed May 27, 2020 5:03 pm
Three bills and a 15min drive...