Peavey Audition HUMMMM

Post Reply
User avatar
jhull54
Reactions:
Posts: 359
Joined: Wed May 27, 2020 6:33 pm
Location: Texas, USA

Got this little amp from Goodwill. Plugged it in, and terrible, banging static and hum from input jack. Suspecting a bad solder joint, I opened it up.

Inside was a tiny spring reverb, that had come unmoored from its sticky tape spot on the chassis. Upon further inspection--yeah, one solder joint was cold. I re-flowed the solder in several places for good measure, and sure enough, that was the fix.

Here are some before and after shots, starting with after.

ImageImageImageImageImage

Sent from my SM-G975U using Tapatalk


Top
User avatar
BatUtilityBelt
Reactions:
Posts: 1941
Joined: Thu May 28, 2020 4:25 pm

A little careful detective work pays off again. Nice!
Top
bc rich
Reactions:
Posts: 154
Joined: Sun Jul 26, 2020 12:26 pm

Goodwill has been very very good to me .There was a pickup only depot a few miles from me so you can imagine the gear now in every corner .
Amp are my weakness i would buy them by the pound, a Marshall VS 200 Bi Chorus combo has to be 70lbs -not in pic .
Most cleaned up to good , some needed jacks , pots ,solder..
And not just amps & the odd guitar, but Dayaks too.
DSCN1175 (2) (1).JPG
You do not have the required permissions to view the files attached to this post.
Top
User avatar
andrewsrea
Reactions:
Posts: 1581
Joined: Wed May 27, 2020 4:43 pm
Location: Lake Saint Louis, MO
Gearlist: 28 Guitars: (2) basses, (2) acoustics, (3) hollow bodies, (3) Semi hollow, (1) Double-neck, (17) Solid-bodies

Good scores and nice that you could repair it! HNAD!
Live life to the fullest! - Rob
Top
User avatar
jhull54
Reactions:
Posts: 359
Joined: Wed May 27, 2020 6:33 pm
Location: Texas, USA

Just an update on this. I replaced the 2 prong cable with a grounded cable, and now this amp is pretty much dead quiet.

Sent from my SM-G975U using Tapatalk

Top
Post Reply

Return to “Solid State Amps”