Guitar buzz noise conundrum

Sub forums for Agile/SX, Gibson, Fender, PRS, Epiphone, Douglas, Other guitars and Lessons. If you would like another added contact the Site Admin.
Post Reply
braindress
Reactions:
Posts: 14
Joined: Fri May 29, 2020 12:39 pm

So I have three guitars. One has a buzz if I don’t touch the strings but when I touch the strings it goes away and I barely need a gate even on high gain amp sims. The other too have the same buzz whether I’m touching the strings or not and the buzz kinda changes depending on which way I’m facing. Even if I get far from the computer it’s still loud. I have to find the perfect spot to minimize it but it never goes away.

Does anyone have any idea of what is going on here?

Guitar 1 is a jackson HH
Guitar 2 is an agile HH
Guitar 2 is a Squier HSH
User avatar
PsychoCid
Reactions:
Posts: 642
Joined: Wed May 27, 2020 9:21 pm

No idea on the technical aspects but my first thought is, add shielding to the cavities of those guitars?

Good luck with it!
User avatar
rrobbone
Reactions:
Posts: 317
Joined: Fri May 29, 2020 4:42 pm

Hard to say. Guitar buzz is a gremlin.

Could be your lights. Could be you need a power conditioner. Could be a bad cord. Or something else electrical causing the interference.

Sheilding the cavities as Cid suggests wouldn't hurt.
"What is this place? Where am I?"
User avatar
Flatline
Reactions:
Posts: 331
Joined: Wed May 27, 2020 4:38 pm
Location: Indiana

Buzz that goes away when touching the strings may be a grounding issue. Have you double checked all your wires to make sure a ground hasn't come loose or there is no cold solder joints?

I have a Duo Sonic HS that had buzz issues when touching the pickguard but not necessarily the strings. After I shielded the pickguard better with some copper tape it went away.
User avatar
RiverDog
Reactions:
Posts: 376
Joined: Wed May 27, 2020 1:35 pm
Location: St Augustine, FL
Contact:

[mention]braindress[/mention] said it happens with 3 different guitars so it's unlikely to be a ground or shielding issue. What's your signal? (pedals, etc.?) I was struggling with similar issues at 2 different times and after much research, I figured out with the first case that the dimmer switch for my ceiling fan/light was the culprit. Moving to a different room fixed it, although it was a pain to do. The other time, I had inadvertently plugged in one of the little power patch cables on my board wrong and I had to take the whole thing apart before I figured it out. Maybe look into those scenarios?
Aaron
---------------
"What is perfect pitch?"
"Perfect pitch is when you toss a banjo into the dumpster, it hits an accordion and they both break."
User avatar
dabbler
Reactions:
Posts: 461
Joined: Sat May 30, 2020 6:39 pm
Location: Maryland

RiverDog wrote: Tue Jul 21, 2020 9:57 am @braindress said it happens with 3 different guitars so it's unlikely to be a ground or shielding issue. What's your signal? (pedals, etc.?) I was struggling with similar issues at 2 different times and after much research, I figured out with the first case that the dimmer switch for my ceiling fan/light was the culprit. Moving to a different room fixed it, although it was a pain to do. The other time, I had inadvertently plugged in one of the little power patch cables on my board wrong and I had to take the whole thing apart before I figured it out. Maybe look into those scenarios?
Depends. If any/all of the guitars are not shielded, I would shield them, especially if they are single coils.

That said, orientation of the guitars having an effect does point to electric fields, which shielding would help with.

Also, if you have dimmable lights in the room, make sure that the dimmers are dimed (full up).
User avatar
Rollin Hand
Reactions:
Posts: 1437
Joined: Wed May 27, 2020 1:38 pm

Shielding may help. They seem to be picking up something. Failing that a HumX or EH Hum Debugger may help.

I had the same problem -- all guitars almost unplayable due to noise. It went away when I moved, save for one guitar. That problem was solved with a new input jack.
"I'm not a sore loser. It's just that I prefer to win, and when I don't, I get furious."
- Ron Swanson
User avatar
fullonshred
Reactions:
Posts: 505
Joined: Wed May 27, 2020 1:41 pm

braindress wrote: Tue Jul 21, 2020 1:18 am So I have three guitars. One has a buzz if I don’t touch the strings but when I touch the strings it goes away and I barely need a gate even on high gain amp sims. The other too have the same buzz whether I’m touching the strings or not and the buzz kinda changes depending on which way I’m facing. Even if I get far from the computer it’s still loud. I have to find the perfect spot to minimize it but it never goes away.

Does anyone have any idea of what is going on here?

Guitar 1 is a jackson HH
Guitar 2 is an agile HH
Guitar 2 is a Squier HSH
I had phantom buzz problems even with several humbucker guitars, while others were dead quiet. It was strongly suggested by some AGF Vets that I had a poorly grounded outlet. Being hard-headed I did not accept that as a likely possibility for a while. When other avenues of action failed to improve matters I moved my amp plug to a "newer" outlet in the same room. That cleared up my problem guitars instantly.

I let the fact that only 3 or so of my 'bucker gits buzzed and the rest were fine keep me from the solution for a long time.
User avatar
LightWingStudios
Site Admin
Reactions:
Posts: 1018
Joined: Wed May 27, 2020 11:34 am
Location: Titusville, FL U.S. of A.
Contact:

Bad cable(s)?
U.S. Manufacturer Of Musical Instrument Protection Accessories: AxeShield HD, AxeSak HD, AmpShield HD, KeyShield HD, PedalShield HD, MixShield HD, AxeGlove And AxeCap.

Visit Us At https://www.LightWingStudios.com

Email us at contact@LightWingStudios.com
Post Reply