Johnny Ramone Mosrite Clone
Posted: Fri Oct 27, 2023 4:20 pm
Thanks for all the help with the zero fret. It was key to getting this done. The original guitar had a shim in the neck because the nut was plastic and cut for crap. The new nut and string bar solved the issue. No need for the neck shim. I put a DiMarzio FS-1 in the bridge, a must. Ileft the original neck pickup since Johnny never used his anyway. The original bridge was sh#t and I had never seen anything like it. Then I somehow came across a Rickenbacker bridge and realize that is what Sun Tzu (joke) originally installed on this guitar...although an extremely cheap knock off. I grabbed a better AllParts version of the bridge and was ready to go.
So new nut, string bar, Wilkinson Grover Clones, DiMarzio FS-1 and AllParts bridge. I was bothered by the fact the strings did not line up over the pole pieces on the bridge pickup. I remembered Tim's lesson on 50 and 52 mm bridge pickups. I figured when Ramone replaced the original bridge pickup with a strat pickup...it just turned out this way. A picture of his original guitar comfirmed it. So for about $275 total...it turned out really nice, considering I was doing all the work! Just need to grab a silver top bell knob for the tone!
Picture proof!
So new nut, string bar, Wilkinson Grover Clones, DiMarzio FS-1 and AllParts bridge. I was bothered by the fact the strings did not line up over the pole pieces on the bridge pickup. I remembered Tim's lesson on 50 and 52 mm bridge pickups. I figured when Ramone replaced the original bridge pickup with a strat pickup...it just turned out this way. A picture of his original guitar comfirmed it. So for about $275 total...it turned out really nice, considering I was doing all the work! Just need to grab a silver top bell knob for the tone!
Picture proof!